55
1. Guide
7. System Setup
S
yst
em
S
e
tup
54
1. Guide
7. System Setup
S
yst
em
S
e
tup
7.4.1 Recording Setup
[Figure 7-41. Recording setup]
[Figure 7-42. Recording setup]
�
In [Recording] setup menu, you can
change the color, brightness, contrast, and
the frame rate for each cameras as well as
setting audio recording.
[Color/Brightness/Contrast]
�
You can set the color, brightness, and
contrast of the selected camera.
�
Use the mouse wheel or the jog/shuttle to
set the value of each option between
0~255.
[Default]
�
Select [Default] button to set the color,
brightness, and contrast to their default
value.
[Frame]
�
You can set the recording frame rate
between 1~30 fps(25fps in PAL) for each
camera using the jog/shuttle dial on the
system. The total recording frame rate can
not exceed 120 fps (100fps in PAL).
[Audio]
�
To record sound with the selected camera,
switch the [Audio] option to “ON” using
the jog/shuttle on the system.
�
Audio recording is supported for one
camera channel only. Setting the [Audio]
option to “ON” will automatically switch
all other channels to “OFF”.
[Apply All]
�
Click the [Apply All] button to apply the
current camera setting to all cameras.
[Camera]
�
Use the jog/shuttle on the system to select
other cameras for set up.
7.4.2 Motion Detection
[Figure 7-43. Motion Detection]
[Figure 7-44. Motion-detection setting]
�
In [Motion Detection] menu, you can set motion
detection area, set motion sensitivity, and enable
or disable alert sound(beeping).
[Setting Motion Detection]
�
To set Motion Detection area, highlight a block of
the area of the channel screen by using the
directional keys, then press Enter key to select
the block.
�
The channel screen is divided into 48 blocks. You
can select as many blocks as you wish up to 48.
[Sensitivity]
�
You can set the motion-detection sensitivity of
each camera to “LOWEST”, “LOW”,
“NORMAL”, “HIGH”, or “HIGHEST”.
[Full Motion]
�
To set the whole channel screen to motion-
detection area, switch the [Full Motion] option to
“ON”. To cancel the whole screen from motion-
detection area, switch the option to “OFF”.
[Beep]
�
To hear a ‘beep’ warning sound when the system
detects movement in motion-detection area, set
the [Beep] option to “ON”. To hear no warning
sound, set the option to “OFF”.
[Appply All]
�
Click the [Apply All] button to apply the current
camera setting to all cameras.
[Camera]
�
Use the jog/shuttle on the system to select other
cameras for set up.
[OK]
�
Press [OK] button to accept any changes made
and return to Setup menu
7.4 Recording Setup
☞
[Note]
�
Recording frame rate may vary
depending on the number of installed
cameras or system load.
