41
GB
It is necessary to daily clean the brazier
and often clean the ash box. The lack of
cleanliness can prevent the starting of the
stove, causing damages to the stove itself and to
the environment (possible emission of unbrunt
material and soot). Do not re-use the pellet possibly
remained in the brazier due to no starting-up.
2
1
CLEANING BY THE TECHNICAL
Check every year
Clean the combustion chamber
Remove the brazier and clean it of any residue. (photo 1)
Remove the central screw that holds the combustion
chamber. (photo 2)
Remove the walls of the combustion chamber and clean
the residue remaining behind this wall. (photo 3)
3
• remove the electrical feed cable;
• remove the cap from the T-joint and proceed with the
cleaning of the ducts. If necessary, at least for the first few
times, call in qualified personnel;
• carefully clean the smoke discharge system: for this,
contact a professional chimney sweep;
• once a year clean the dust, cobwebs, etc. from the zone
behind the internal covering panels, paying particular
attention to the fans.
Cleaning the fans
The stove is furnished with fans (environmental and
smoke) positioned at the rear and below the stove.
Eventual deposits of dust or ash on the blades of the
fan can cause an imbalance in the fans leading to noisy
performance. It is, therefore, necessary to clean the fans
at least once a year.
Since said operation requires dismantling several parts of
the stove, have the fans cleaned only by our Technical
Assistance Centre.
Season end cleaning
At the end of the season, when the stove will not be used
for some time, it is advisable to perform a thorough and
general cleaning:
• Remove all the pellets from the container and the screw
feeder;
• Carefully clean the brazier, the brazier support, the
combustion chamber and the ash box.
Once the preceding points have been observed, it only
means that the state of the stove has been verified. It is
necessary to thoroughly clean the smoke discharge tube
or flue and check the condition of the basket.
If necessary, order a new one from our Authorized
Assistance Centre.
If necessary, lubricate the hinges of the door and the
handle. Also check the ceramic fibre cord near the glass,
on the internal wall of the door; if it is worn or too dry,
order a new one from the Authorized Assistance Centre.
Cleaning the clearing system
Until a reasonable experience is acquired regarding
the operating conditions, it is advisable to perform this
maintenance on at least a monthly basis.
