35
GB
Daily repeat AUTO
Using the function AUTO, you
can repeat the single automatic
switching on and off you
selected every day.
You just need to press the key
AUTO (1) for at least two seconds
to activate the function. You will
read the words AUTO (2) on the
display of the remote control.
Press SEND (3) to confirm your
selection and transmit it to the
pcb of the stove.
The LED chrono-thermostat
will light up on the control board indicating that the
programming is on.
You can deactivate the automatic repeat whenever you
want just pressing the key AUTO again for at least two
seconds. The words AUTO will disappear from the display.
Press SEND (3) to confirm your selection and transmit it to
the pcb of the stove.
3
1
2
Always clean the brazier before starting an
automatic switching on in order to avoid
any possible missed starts up which would
damage your stove and the environment.
“OFF”
: the stove is off or it is in a shutting
down phase.
“FAN-ACC”
: the stove is in the phase
of preheating the resistor, preceding
lighting.
“LOAD WOOD”
: the stove is loading
pellets. On the control board the LED
resistance is on.
“FIRE ON”
: The stove is in the flame
stabilization phase (flame present).
“ON 1”
: the stove is in the operational
phase at minimum power.
“ECO”
: the stove has reached the
temperature set by the user and is in the
energy saving phase. In this phase it is
not possible to modify the power setting.
If the temperature is set at 41°C the stove
will remain in continuous operation at
the programmed work power without
passing to the economy mode (ECO).
“STOP FIRE”
: the stove is in a self-
cleaning of the basket phase; the smoke
extractor runs at the maximum speed
and the pellet loader at minimum.
“ATTE”
: you will read these letters when
you try to start up the stove while it is
completing a cooling cycle. Wait until
the cooling phase is completed before
proceeding with a new switching on.
If you need to replace the
batteries of the remote
control, remove the back
cover as shown in the
picture. Replace the old
batteries with the new ones
respecting the polarity +
and -.
The batteries needed are
AAA, 1,5 V.
Replace the batteries of the remote control
Display information
