INSTALLATION INSTRUCTIONS
In-Wall Tank and Carriage
1206758-2-C
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or kallista.com.
2 of 12
THANK YOU FOR CHOOSING KALLISTA
We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual
before you install your KALLISTA product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.
BEFORE YOU BEGIN
IMPORTANT! 2x6 framing is required for this product. 2x4 framing will not be deep enough to accommodate
the carriage assembly.
IMPORTANT! In areas with freezing temperatures, install on an interior wall. If installed on an exterior wall,
provide adequate insulation to prevent the possibility of freezing.
NOTE: This device is not intended to be used as a retrofi t device for 1.28 gpf (4.8 lpf) water closets.
NOTE: Performance may vary. This product was not tested with toilets not listed as compatible.
Observe all local plumbing and building codes.
Please read all instructions before you begin.
Carefully inspect the carriage and tank for damage.
During installation, make sure the inlet tube connections and gaskets remain fully engaged to ensure a
watertight seal.
Shut off the water supply.
KALLISTA reserves the right to make revisions in the design of products without notice, as specifi ed in the
Price Book.
TOOLS AND MATERIALS
• Assorted electrical
tools
Optional:
• Conventional
woodworking
tools and materials
• Cement board,
24" (610 mm) x
24" (610 mm) min
Plus:
2" Hole Bit
1/4" x 2" (51 mm)
Min Lag Bolts
Silicone Plumbers
Grease
Assorted Drill Bits
