INSTALLATION INSTRUCTIONS
In-Wall Tank and Carriage
1206758-2-C
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or kallista.com.
3 of 12
1. INSTALL THE FRAMING
19" (483 mm)
Waste
Outlet
Pipe
4" (102 mm)
9-1/2" (483 mm)
2x6 Studs
4" (102 mm)
Ø 3-9/16"
(90 mm)
IMPORTANT!
This installation requires 2x6 studs. Note the center-to-center stud dimension is not standard.
IMPORTANT!
Note the 4” (102 mm) dimension from the front edge of the framing to the center of the outlet pipe.
This dimension is critical for the installation.
NOTE:
Refer to the specifi cation sheet for more details and dimensions for roughing-in.
NOTE:
The waste outlet pipe may need to be relocated for this installation.
NOTE:
The recommended install height from the fi nished fl oor to the toilet rim is 16-1/8” (410 mm).
NOTE:
A plastic elbow is supplied with this product. A cast iron elbow may be required by codes in some areas.
The height of the toilet drain pipe may need to be adjusted if the cast iron elbow is used.
Construct the stud pocket using lag bolts. Firmly insert the inlet pipe completely into the inlet hole.
Install the stud pocket following the dimension shown.
The centerline of the stud pocket should intersect with the center of the waste outlet. The center of the waste
outlet should be exactly 4” (102 mm) from the front edge of the framing.
