10
+VDC
DC Power Supply Positive Pole, supply voltage range: DC 24 ~ 75VDC, recommended
24VDC or 36VDC work.
A+
A phase winding interface for stepper motor,Open-loop steppingand closed-loop
stepping are used, DC servo is not used for this interface
A-
A-phase winding interface
of stepper motor
B+
B phase winding interface
for stepper motor
B-
B-phase winding interface
of stepper motor
The power supply voltage can work normally between the specified ranges. The driver is
prefer ably powered by naun regulated DC power supply,or a transformer buck+bridge rectifier
+ capacitor filter. Note, however, that the peak voltage ripple after rectification should
not exceed its specified maximum voltage. It is recommended that the user supply power with
a DC voltage lower than the maximum voltage to prevent the grid from fluctuating beyond the
operating range of the driver voltage.
If using a regulated switching power supply, be aware that the output current range of the
switching power supply must be set to maximum.
Please note:
When wiring,pay attention to the positive and negative poles of the power supply,do not
reverse connection;
It is better to use an unstable power supply;
The output capacity of the power supply current should be greater than 60% of the set current
of the driver when an unstable power supply is used;
When a regulated switching power supply is adopted, the output current of the power supply
shall be greater than or equal to the working current of the driver;
To reduce costs, two or three drives can share a power supply, but the power supply should
be large enough.
4.2.5 RS485 bus communication interface
The RS485 port is a duplex with shielded RJ45 terminals (16 pins near the driver terminal
side)
