Operation Instructions for Air-to-water Heat Pump Split ECO HOME
Operation Instructions for Split Versati
10
SPLIT TYPE
(d) It will be deactivated when the unit is turned off.
2.2.8 Quiet Timer
time period.
[Operation Instructions]
(1) Go to the
FUNCTION
page and locate
Quiet timer
, then, access to the
QUIET TIMER
setting page.
(2) At the
QUIET TIMER
setting page, select “
Start time
” or “
End time
” through the Left/Right keys
.
(3)
are determined to save this setting. If so, press the “OK” key
. If not, press the “Cancel” key
to
not save this setting.
(4) When the setting is saved, the control then will back to the
FUNCTION
page and the cursor will be where
the “
Quiet timer
” option is, then by the Up/Down key
, it can be set to be “
On
” or “
Off
”.
[Notes]
(a) Once it is activated, it should be deactivated manually.
(b) This setting will be memorized upon power failure.
(c) The saved “
Start time
” and “
End time
” will be memorized upon power failure.
(d)
2.2.9 Weather-dependent Mode
For areas with large change of diurnal temperature, in order to avoid the user to set the leaving water
temperature or room temperature too often, this function will adjust automatically depending on the environmental
temperature.
[Operation Instructions]
Go to the
FUNCTION
page and locate
Weatherdepend
, then, configure it through the Up/Down key
, “
On
” or “
Off
”. See section
2.3.2
for more details.
[Notes]
(a) Once it is activated, it should be deactivated manually.
(b) This setting will be memorized upon power failure.
(c) At the “
Parameter View
” page, it is able to check the set point at the Weather-dependent Mode.
(d) When it is activated, it is allowed to set the room temperature but the set point does not take effective.
However, when it is deactivated, the unit will run according to this set point.
(e) It can be set to “
On
” or “
Off
” no matter if the unit is in operation or not, but be activated only when the unit
is in operation.
