13
User Defined Binding:
1)
Hold
the [Mode] Key until “SEL” appears in Display
2) Press the [7] Key. (Transmitter now waits for a two digit
Address to assign to the Receiver)
3) Key in an (unassigned) Address for the Receiver you wish
to Bind.
4) Connect power to the Receiver you wish to Bind and press
the [On/Off] Key.
Note: The [On/Off] Key must be pressed within ten seconds after
connecting power to the Receiver.
The Display will show that the Receiver is Bound with the Address
that you selected.
Note: If the Address was previously assigned it will be Erased
and the Receiver using that Address will be Unbound. (see
Unbinding)
(Sec 3.2.4)
3.2.4 Unbinding:
1)
Hold
the [Mode] Key until “SEL” appears in Display
2) Press the [7] Key. Display shows “_ _”. (Transmitter waits for a
two digit Address to Unbind)
3) Key in the Address you wish to Unbind.
4) Press the [On/Off] Key to Unbind the selected address.
The Display will show that the Receiver that you selected is
Unbound. The Address will also be Erased from the “Bound
Receiver List” but not from the “Receiver Groups List”. (for more
on groups. see Using List Modes. (Sec 3.3)
Note: Bound Receiver Addresses are available for review.
(see Using List Modes: View Receiver and Group List)
(Sec 3.3.3)
3.2.5 Send Wake Command:
After one hour of no activity receivers will go to sleep.
To wake receivers:
1)
Hold
the [Mode] Key until “SEL” appears in Display
2) Press the [On/Off] Key. The Transmitter will search for and
Wake any Bound Receivers.
When the Display shows that the System is Ready, the Receivers
are awake and ready to use.
Summary of Contents for RC
Page 1: ...Transmitter User Guide...