12
3.2 Using Standard Modes
3.2.1 Delay Mode
Receiver will pause for 30 seconds after receiving a command,
then return to its original position. Either the Servo or the Receivers
internal Relay can be set to Delay.
Set Delay Mode on a Receiver:
1) Select the Receiver you wish to set to Delay.
2)
Hold
the [Mode] Key until “SEL” appears in Display.
3) Press the [1] Key to select Delay Mode. Display shows “S?r”.
4) Press the [*] Key for Servo or [#] Key for Relay. Display flashes “SEt”.
The servo (or) relay is now set to Delay and it’s function indicator
will blink, showing Delay is set.
Tip: To set both the servo and relay to Delay: Use the
Tandem Mode. (Sec 3.2.2)
Clear Delay Mode:
1) Select the Receivers address.
2)
Hold
the [Mode] Key until the display shows “SEL”.
3) Press the [0] Key. Display flashes “CLr”.
Delay Mode is now cleared on the selected Receiver.
3.2.2 Tandem Mode
Servo and Relay operate simultaneously with a push of either the
[*] or [#] Key.
Toggle Tandem Mode ON or OFF:
1) Select Receivers address.
2)
Hold
the [Mode] Key until “SEL” appears in Display.
3) Press the [2] Key.
“t” will appear in the Display showing that this Receiver is set to
Tandem Mode.
Note: Repeat steps 1-3 to toggle Tandem Mode to OFF.
3.2.3 Binding Mode
Bind Receiver to Transmitter and create Receiver Address.
Bind Receiver Sequentially:
1)
Hold
the [Mode] Key until “SEL” appears in Display.
2) Press the [6] Key. “bnd” will appear in Display.
3) Connect power to the Receiver you wish to Bind and press
the [On/Off] Key.
Note: The [On/Off] Key must be pressed within ten seconds after
connecting power to the Receiver.
The Display will show the Receivers Address that was Sequentially Bound.
Summary of Contents for RC
Page 1: ...Transmitter User Guide...