PK3512_09_07 • REMOTE ACCESS CONTROLLER - 660G
10
Mounting Keypad Reader
IMPORTANT: The installation bag supplied with the
kaypad reader includes screws for metal panel
installation or insert and wood screws for drywall
installation. Use the relevant screws according to
which surface the keypad reader will be installed on.
!
IMPORTANT: Refer to drilling template in Annex C
to select the drill size of the mounting holes for the
keypad reader.
!
1. To install the keypad reader (G) in the desired location, use
the template Annex C to mark the holes for the cable and
screws.
2. Wearing safety glasses, drill the holes in the wall according
to the diameters indicated in the drilling template dependent
on the type of surface the keypad reader is installed on.
3. Connect the cable from the keypad reader (G) to the
terminal blocks on the controller board (B) as per Annex A,
Table 1.
4. Caution with keypad side table 5 or 12 volts. A jumper
plug is installed on one of the pins. This is the default
setting for 12 volt operation. Incorrect voltage selectable
may cause damage refer to manufacturers specification
document provided with reader.
Step 8: Install strain relief bushing (for
power adaptor only)
One strain relief bushing (R) is provided in the hardware
bag to secure the power adaptor (E or F) cable leading into
the controller box to help prevent the possibility of wire
tampering.
or
R
Figure 12
E
F
NOTE:
The strain relief bushing (R) provided in the hardware
bag has a movable attached plug. When the plug is
removed, It leaves an opening that allows a double wire
flat cable to be routed in.
Determine the routing needed for the wiring of the power
adaptor (E or F) from AC power source to the controller box.
Remove the keyhole knock-out, on the upper contour of the
controller box.
To remove the knock-out, from the inner side of the controller
box, use a hammer and screwdriver, and tap out the small
metal disk.
Remove the movable plug from strain relief bushing (R), route
the power adaptor (E or F) flat cable in. Leave a cable length
long enough in the controller box to plug the power adaptor (E
or F) cable into the power jack cable assembly (C) mounted in
the inner wall of the controller box. To obtain the desired strain
relief effect, firmly close the plug of the strain relief bushing (R)
onto the flat cable.
Route the cable of the power adaptor (E or F) in the knock-out
slot of the controller box. Insert the strain relief bushing (R) as
per figure 12. The access panel of the controller box can now
be closed
Step 9: Completing the installation
1.
I f the panel door was removed, reinstall the door on the
RAC 4 enclosure
2. Bend the two tabs of the panel door with pliers to a
maximum of 30 degrees as shown in Figure 13.
Figure 13
3. Plug the power adaptor into the AC power source.
4.0 System Installation Overview
(Continued)
