User information
Angled mincer WW 130/160
WWD130
10.06.2022
Speicherdatum 10.06.2022 11:53:00
Seite 14
The angled mincer is a self-supporting construction, which meets all
static and dynamic requirements. The hygiene requirements of the
EC machine guide lines and the EC guide lines for the handling of
meat and meat products are adhered to.
The external machine parts are made from corrosion-resistant
material. The machine surface as a whole is specially treated and
hence easily cared for. Large doors enable ease of access for
cleaning and maintenance work.
The working worm is driven by the main motor via V-belts and the
feed worm is driven by a geared motor via a roller chain.
4.2
Workplace
The workplace for the operator is located in front of the machine.
4.3
Installing the working worm and the cutter assembly
-
Switch
main switch
to "0".
- Lightly grease the 4-sided carrier piece (Fig. 2, No. 15) and the
knife pin (Fig. 2, No. 17).
-
Insert the
working worm
with the 4-sided carrier piece (Fig. 2, No.
15) slowly while rotating. When the worm contacts the collar,
rotate the worm until the 4-sided carrier piece slides into the
carrier. Then push the worm in as far as it will go.
- The end face of the worm must be somewhat lower than the end
of the cutting space.
-
Place the
cutter assembly parts
of the desired cutter assembly
onto the knife pin. Observe the prescribed assembly sequence.
See chapter 4.4, Cutter Assembly, or the instructions of the cutter
assembly manufacturer.
Caution:
Only install knives and discs from the same
manufacturer!
- Insert support cross and/or properly-sized placement ring in such
a way that the cutter assembly extends somewhat from the worm
housing.
- Tighten the locking ring to cutting pressure by hand.
Excessive tightening causes a high level of friction, which leads to
increased wear on the discs and knives and increased warming of
the meat.
- Close discharge guard.
- The meat mincer is now ready for operation.
- Disassembly is carried out in the reversed sequence after the
locking ring has been removed.
