28
Operations
Table 3-6: Card Number Configuration Settings
Default card number is 15.
3.7.2
SSI_TRIG
As an output, the SSI_TRIG signal reflects the trigger event signal
in an acquisition sequence. As an input, the PCIe-
69834
accepts
the SSI_TRIG signal to be the trigger event source. The
signal is
configured in the rising edge-detection mode.
3.8
Multi-boot
The PCIe-
69834
supports software-based firmware updates. If
firm-ware updates fail, the system may be unable to recognize
the
module, in which case the following steps may solve the
problem.
1. Config SW2 to "on"
2. Install the module and restart the system
3. If the module is recognized, update firmware again
(ensure the firmware you updated is workable)
4. Turn off the system, config SW2 to "off" and restart the
system.
The default state of SW2 is "off".
If the problem remains, please contact FAE.
ON
OFF
OFF
ON
9
ON
OFF
ON
OFF
10
ON
OFF
ON
ON
11
ON
ON
OFF
OFF
12
ON
ON
OFF
ON
13
ON
ON
ON
OFF
14
ON
ON
ON
ON
15
Slider 1
Slider 2
Slider 3
Slider 4
Card #
Summary of Contents for PCIe-69834
