XV-FA90BK/XV-FA92SL/XV-FA95GD
1-10
Prior to performing the following procedure, remove
the top cover and the front panel assembly.
Removing the traverse mechanism
assembly (See Fig.15 and 16)
Prior to performing the following procedure, remove
the top cover and the front panel assembly.
Eject the main tray assembly toward the front
referring to “Removing the main tray assembly”.
Remove the two screws
L
and pull out the clamper
base assembly upward.
Disconnect the card wire from connector CN210 on
the servo control board.
Remove the four screws
M
and the traverse
mechanism assembly upward.
1.
2.
3.
4.
Remove the two screws
N
on the back of the front
panel assembly.
Disconnect the card wire from connector CN813 and
CN806 on the power switch board.
1.
2.
Removing the power switch board
(See Fig.17)
Remove the six screws
O
on the back of the front
panel assembly.
Disconnect the card wire from connector CN812 on
the operation switch board.
1.
2.
Removing the operation switch board
(See Fig.17)
Remove the two screws
P
on the back of the front
panel assembly.
Disconnect the card wire from connector CN805 on
the FL display board.
1.
2.
Removing the FL display board
(See Fig.17)
<Front panel assembly>
When reattaching the traverse mechanism
assembly, pass the card wire extending
from the traverse mechanism assembly
through the notch
d
of the elevator base.
CAUTION:
There is no need to remove the loading
base assembly.
REFERENCE:
Fig.17
L
Servo control board
CN210
Fig.15
L
Clamper base
assembly
Fig.16
Servo control board
CN210
M
M
Traverse mechanism
assembly
Notch d
O
O
Operation switch board
CN812
CN813
O
P
CN805
FL display board
CN806
N
Power switch board
