JVC VR-X1600U, Instructions Manual

Page: 129 / 204

123
You may add the following drives as a storage destination for
recorded images, archiving, and export data.
Note:
●
For details of compatible devices and additional HDD,
consult your nearest JVC KENWOOD dealer. You can
also check on our website.
●
For formatting additional external HDD, see "When an
External HDD has been added" (
A
Page 71).
●
For setting NAS as the archive destination, see "Specify
NAS as the archiving destination" (
A
Page 74).
●
For building a RAID configuration using the built-in HDD,
see "Building a RAID Configuration" (
A
Page 72).
Connecting a UPS (uninterruptible power supply) to the HDD
will protect it from damage by automatically shutting down all
operations prior to switching off the power supply in the event
of a power failure.
Note:
●
For details of compatible UPS, consult you nearest JVC
KENWOOD dealer or service center. In some cases, a
UPS used with VR-N1600/VR-N900 series may not work
with this unit.
䡵
Connection and setup
1
Set up the UPS.
●
For details, refer to the instruction manual of the
device.
2
Press and hold down the [OPERATE] button for
about 2 seconds to shut down the system and
switch off the power switch on the rear panel
3
Connect a UPS communication cable to the
SERIAL terminal on the rear panel
4
Switch on the power of the UPS and then this
unit
Caution:
●
Make sure that the UPS communication cable is
connected before switching on the power of this unit.
●
Do not disconnect the communication cable when
operations are in progress.
●
When a power failure occurs while formatting a HDD or
archiving, subsequent operations may be affected even
when a UPS is connected.
●
The recorded images may not be played back properly if
they are not archived before the power failure.
●
The connecting cable and settings vary depending on the
UPS used.
Adding a Drive
Type Connection method
DVD drive One of the SERIAL terminals on
the rear panel
External HDD A SERIAL terminal or eSATA
terminal on the rear panel
(
A
Page 71)
Built-in HDD For details, consult our authorized
dealers or JVC KENWOOD
service centers.
NAS Network (LAN1) connection
(
A
Page 73)
Using UPS
A
UPS Connect to a SERIAL terminal
on the rear panel.
B
Supplied power
cord Connect the power cable of
this unit to the power outlet of
the UPS.