JVC VN-X35U - Network Camera, Instructions Manual

Page: 23 / 111

23
Inner Tripod Base Mounting Screw
Make use of 1/4-20UNC screw. The length of the
mounting screw shall be between 6 mm to 7 mm
from the mounting surface.
Note:
●
Using a screw with a length longer than
specified may damage the internal parts of
the camera, while using a length shorter than
specified may cause the camera to fall off.
Use a washer to adjust the length from the
mounting surface.
The CS mount is adjusted to the widest point of
the applicable range by default. When using the
zoom lens, or when the lens remains out of focus
upon using the focus ring, readjustment is
required.
●
Follow the method below when necessary to
adjust the back focus.
●
In order to adjust the back focus accurately,
open the lens iris using Focus Assist Mode,
or put on ND filter. See the chapter of Focus
Assist Mode. (ND filter is used to evenly
reduce the amount of light entering the lens
at all wavelengths.)
●
Connect a video monitor to the [MONITOR
OUT] terminal at the rear of the unit, followed
by adjusting as follows.
Fixed focus lens
Adjust when the lens cannot be brought into
focus using the focus ring.
1
Loosen the back focus fastening screw by
using a Phillips screwdriver and turning it in
the anti-clockwise direction
2
Shoot a fine pattern as far as possible
3
Set the focus ring of the lens to
∞
4
Turn the back focus adjustment ring to obtain
a sharp focus
5
Tighten the back focus fastening screw by
turning it in the clockwise direction, and
ensure that it is securely fastened
Zoom lens
Perform the zooming operation (Tele - Wide) and
adjust accordingly if it is out of focus.
1
Loosen the back focus fastening screw by
using a screwdriver and turning it in the anti-
clockwise direction
2
Shoot the object or a fine pattern that is
farther away than the object
3
Set the zoom lens to Tele and turn the lens
focus ring to adjust the focus
4
Set the zoom lens to Wide and turn the back
focus adjustment ring to adjust the focus
5
Repeat Steps 3. and 4. for two to three times
6
Tighten the back focus fastening screw by
turning it in the clockwise direction, and
ensure that it is securely fastened
Back Focus Adjustment
Mounting Plate
Washer
Max. 7 mm
(17/64 inch)
Min. 6 mm
(15/64 inch)
Back Focus Adjustment Ring
Back Focus Fastening
Screw (M2.6)
Lens Focus Ring
Tighten
Loosen