11
7
Connecting the satellite (front, center and surround) speakers to the subwoofer
CAUTION
• If you connect speakers other than the supplied ones, use speakers of
the same speaker impedance (SPEAKER IMPEDANCE) indicated
near the speaker terminals on the rear of the powered subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
• When installing the satellite speakers on the wall;
– Be sure to have them installed on the wall by qualified personnel.
DO NOT install the satellite speakers on the wall by yourself to
avoid unexpected damage from falling off the wall due to incorrect
installation or weakness in wall structure.
– Care must be taken in selecting a location for speaker installation
on a wall. Injury to personnel or damage to equipment may result
if the speakers installed interfere with daily activities.
Precautions for daily use
• When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
• When holding a speaker, always grasp the lower portion.
• Do not lean against the speakers, as the speakers could fall down
or break, possibly causing an injury. Especially be careful that
children do not lean against them.
• Do not reproduce sounds at so high a volume that the sound is
distorted; otherwise, the speakers may be damaged by internal
heat buildup.
• Connect the black cords to the black (
r
) terminals.
• Connect the white cords to the (
q
) terminals
referring to the table below:
Speaker cord
FRONT SPEAKERS (LEFT)
White
FRONT SPEAKERS (RIGHT)
Red
CENTER SPEAKER
Green
SURROUND SPEAKERS (LEFT)
Blue
SURROUND SPEAKERS (RIGHT)
Gray
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Powered subwoofer
SP-PWC43
Front speakers
SP-THC43F
Surround speakers
SP-THC43S
Center speaker
SP-THC43C
Connections
Do not connect the power cord until all other connections have been made.
EN_TH-C43[C]3.book Page 11 Tuesday, March 14, 2006 4:44 PM
