JVC SR-VS30E, Instructions Manual

Page: 40 / 92

Filename [SR-VS30E_2-EN.fm]
Masterpage:Left
40
EN
Page 40 February 1, 2002 3:23 pm
TIMER RECORDING (cont.)
24 Hour Express
Timer Programming
You can programme a timer recording that starts within 24 hours
using the JOG dial on the recorder.
A
Enter the programme mode.
Press 24H EXPRESS
#
on the recorder. The start time
indicator ( ) starts blinking on the front display panel.
●
The current tape speed and VPS/PDC setting appear on the
front display panel, but it is impossible to change the setting.
You can only change the setting after programming
(
墌
pg. 42).
B
Set the programme start/stop time and
channel.
Turn the JOG dial to the left or right to set the time you
want recording to start.
●
One click stop of the JOG dial changes the time in 5-minute
intervals.
Push the JOG dial. The stop time indicator ( ) starts
blinking on the front display panel. Turn the JOG dial to
the left or right to set the time you want recording to stop.
Push the JOG dial. Turn the JOG dial to the left or right to
select the channel you wish to record.
●
You can cancel the setting at any time by pressing and holding
the
JOG dial for more than 3 seconds or pressing
&
on the
remote control. Repeat the step 2 .
C
Engage the recorder’s timer mode.
Press 24H EXPRESS
#
. The recorder turns off
automatically and “
#
”
appears on the front display
panel.
●
To disengage the timer mode, press
#
( TIMER ) or
24H EXPRESS
#
again.
Before performing the 24 Hour Express Timer
Programming:
●
Make sure that the recorder’s built-in clock is set properly.
●
Select the deck.
●
Set the tape speed.
●
For the VHS deck:
Insert a VHS (or S-VHS) cassette with the record safety tab
intact.
For the DV deck:
Insert a Mini DV cassette with the erase protection switch
set to “REC”.
1 3 2
SR-VS30E_1-EN.book Page 40 Friday, February 1, 2002 3:35 PM