JVC RX-DP10RSL, Service Manual

Page: 5 / 132

RX-DP10VBK/RX-DP10VSL
RX-DP10RSL
1-5
Remove the eight screws A attaching the top cover
on both sides of the body.
Remove the three screws B on the back of the body.
Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
1.
2.
3.
Disassembly method
Removing the top cover (See Fig.1)
Prior to performing the following procedure, remove
the top cover.
Cut off the tie band fixing the harness.
Disconnect the harness from the connector CN971,
CN977, CN983 and CN985 on the system control
board (see fig.5) and CN973 on the front AV in board
(see Front panel assembly section/ fig.2).
Remove the screws a and b, and remove each earth
wires.
Remove the three screws C attaching the front panel
assembly.
Remove the four screws D attaching the front panel
assembly on the bottom of the body. Detach the front
panel assembly toward the front.
1.
2.
3.
4.
5.
Removing the front panel assembly
(See Fig.2 and 3)
Removing the tuner unit & RF remote unit
(See Fig.2 and 4)
Prior to performing the following procedure, remove
the top cover.
Disconnect the card wire from the connector CN1 on
the tuner unit.
Remove the two screws E' attaching the tuner unit to
the rear panel.
Disconnect the harness from the connector CN1 on
the RF remote unit.
Remove the nut E'' attaching the RF remote unit to
the rear panel.
1.
2.
3.
4.
Note : RF remote unit is not in B/E/EN version.
THE INTRODUCTORY NOTES in Figs :
Gray parts do not correspond to B/E/EN
version.
Fig.1
Fig.2
Fig.3
Fig.4
A
4
A
4
B
Top cover
C
a
(fixing the
earth wire)
b
(fixing the
earth wire)
Tie band
Harness
band
Tuner unit
RF remote unit
CN1
D
E
F
E
F F F
F
Power cord
stopper
C
Front panel assembly
Front panel
assembly
D
Rear panel
E E
E' E''
E E
E
CN1