14
Remote Programming
The remote control is programmed with DVD codes for power on, power off, play, stop, fast-forward,
rewind, previous chapter, next chapter, tray open/close, and still/pause operation.
1) Find the DVD player brand from the list of codes shown below.
2) Slide the first 2-way selector switch to “TV” and the other 2-way selector switch to “DVD”.
3) Press and hold down the D
ISPLAY
button.
4) With the D
ISPLAY
button held down, enter the first code number listed with the 10 key pad.
5) Release the D
ISPLAY
button.
6) Confirm the operation of the DVD player.
• If your DVD player does not respond to the first code, try the others listed. If it does not respond to any
code, try the Search Codes Function at the bottom of the page.
• After you program your remote, some DVD buttons may not work properly. If some buttons do not work
properly, use the remote control which came with your DVD player.
Search Codes Function:
1) Slide the first 2-way selector switch to “TV” and the other 2-way selector switch to “DVD”.
2) Press the DVD P
OWER
and R
ETURN
+ buttons. Hold for at least three seconds and release.
3) Press DVD P
OWER
, see if the DVD player responds.
4) If there was a response, press R
ETURN
+. The operating codes are now set. If there was no response,
repeat Step 3. If you repeat Step 3 30 times without a response, use the manufacturers remote control
which came with the DVD player.
5) Press R
ETURN
+ to exit.
DVD setup