Remote Programming 13
VCR setup
The remote control is programmed with VCR codes for power on, power off, play, stop, fast-forward,
rewind, pause, record, channel up, and channel down operation.
1) Find the VCR brand from the list of codes shown below.
2) Slide the first 2-way selector switch to “TV” and the other 2-way selector switch to “VCR”.
3) Press and hold down the D
ISPLAY
button.
4) With the D
ISPLAY
button held down, enter the first code number listed with the 10 key pad.
5) Release the D
ISPLAY
button.
6) Confirm the operation of the VCR.
• If your VCR does not respond to the first code, try the others listed. If it does not respond to any code,
try the Search Codes Function at the bottom of the page.
•
Some manufacturer’s VCR’s may not respond to the TV/VCR button, even if other buttons work properly.
•
To Record, hold down the R
EC
button on the remote and press P
LAY
.
Search Codes Function:
1) Slide the first 2-way selector switch to “TV” and the other 2-way selector switch to “VCR”.
2) Press the VCR P
OWER
and R
ETURN
+ buttons. Hold for at least three seconds and release.
3) Press VCR P
OWER
, see if the VCR responds.
4) If there was a response, press R
ETURN
+. The operating codes are now set. If there was no response,
repeat Step 3. If you repeat Step 3 80 times without a response, use the manufacturers remote control
which came with the VCR.
5) Press R
ETURN
+ to exit.