12
Remote Programming
Setting the CATV, VCR and DVD Codes
You can program your remote to operate your cable box, satellite receiver, VCR or DVD player by using
the instructions and codes listed below. If the equipment does not respond to any of the codes listed
below or to the code search function, use the remote control supplied by the manufacturer.
Cable Box or Satellite setup
The remote control is programmed with CATV and/or Satellite codes for power on, power off, channel up,
channel down, and 10 key operation.
1) Find the CATV/Satellite brand from the list of codes shown below.
2) Slide the 2-way selector switch to “CATV”.
3) Press and hold down the D
ISPLAY
button.
4) With the D
ISPLAY
button held down, enter the first code number listed using the 10 key pad.
5) Release the D
ISPLAY
button.
6) Confirm the operation of the Cable Box/Satellite receiver.
• If your CATV or Satellite box does not respond to the first code, try the others listed. If it does not
respond to any code, try the Search Codes Function at the bottom of the page.
Search Codes Function:
1) Slide the 2-Way Mode Selector switch to CATV.
2) Press the TV P
OWER
and R
ETURN
+ buttons. Hold for at least three seconds and release.
3) Press TV P
OWER
, see if the CATV or Satellite box responds.
4) If there was a response, press R
ETURN
+. The operating codes are now set. If there was no response,
repeat Step 3. If you repeat Step 3 52 times without a response, use the remote control which came
with the equipment.
5) Press R
ETURN
+ to exit.
