1-19
OFF
Standard setting
START
Menu SW information is loaded from a store area.
OFF
Standard setting
START
Menu SW information is saved to a store area.
CANCEL
Standard setting
EXECUTE Resets all EEP-ROM data to default settings except adjustment data, hour meter data, and
IEEE1394 ID data.
Default settings at time of shipment differ by market region.
I: for Japan, U: for USA, E: for EU, EC: for China
Contents of the EEP-ROM can be edited directly
ADR: Address (0
x
000-0
x
7DF) display
DATA: Display of data embedded in address shown by ADR
Operation procedure
1. Rotate the SHUTTER dial to move the cursor to MEM.EDIT.
2. Push the SHUTTER dial to blink the “ADR” parameter.
3. Then rotate the SHUTTER dial to adjust the specified value.
4. Next, push the SHUTTER dial to blink the DATA parameter.
5. Rotate the SHUTTER dial to adjust the specified value.
6. Finally, push the SHUTTER dial to store the data.
(NOTE)
Data that is crucial for the system is stored in the EEP-ROM, and making unadvised changes to it can cause the
unit to stop operating correctly. Please do not use anything other than the IEEE1394 ID setting.
Item
Parameter
MEMORY SW
LOAD
MEMORY SW
SAVE
ALL RESET
MEM.EDIT
1.5.13
OTHERS menu
In a service menu, place the cursor on “OTHERS” and push the SHUTTER dial to display the OTHERS menu.
(
䡺
is default setting when shipped from factory)
Table 1-5-13 OTHERS Menu Setting Items List
Fig. 1-5-13
Operation ways are almost same as CAMERA1 MENU, so please refer it.
– – –
O T H E R S – – –
M E M O R Y S W L O A D
: O F F
M E M O R Y S W S A V E
: O F F
A L L R E
S E T
: C A N C E L
M E M . E D I T
A D R : 3 9 8
D A T A : 4 F
P A G E
B A C K
