2
1
2
3
4
5
6
9
7
1
(ILLUMINATION)
(PARKING BRAKE)
3
8
2
C D
A
B
*1
*1
VIDEO OUT
LINE IN
VIDEO IN
REVERSE
GEAR
SIGNAL
2nd AUDIO OUT
L
R
L
R
L
R
L
R
REVERSE GEAR SIGNAL
REMOTE
SENSOR
RESET
3
2
1
4
AV OUTPUT
R
L
VIDEO
POWER
AV BUS
AUDIO
TV ANTENNA
*4
JVC TV tuner unit KV-C1008
AV BUS cord (supplied for KV-C1008)
Diversity antennas
(supplied for KV-C1008)
Apple
iPod
JVC
D. player
*5
*5
*6
*6
*6
*6
Left speaker (rear)
Right speaker (front)
Left speaker (front)
Right speaker (rear)
15 A fuse
Yellow*
2
Blue
Red
Orange with white stripe
To cellular phone system
To car light control switch
Fuse block
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch)
To metallic body or chassis of the car
*
1
Not included with this unit.
*
2
Before checking the operation of this unit
prior to installation, this lead must be
connected, otherwise power cannot be
turned on.
Black
To an accessory terminal in the fuse block
Gray with black
stripe
White
White with black
stripe
Green with black
stripe
Gray
Green
Purple with black
stripe
Purple
Rear ground terminal
Light green
Brown
Crimp
To parking brake of the car (see below)
To the remote lead of other equipment (200 mA max.)
To automatic antenna if any (250 mA max.)
Blue with white stripe
ELECTRICAL CONNECTIONS
Before connecting...
Check the wiring in the car carefully. Incorrect connection may cause serious damage to the units. The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Connect the wiring harness to the main unit.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
D
Connecting the external components
CD changer, Apple iPod
®
, or JVC D. player
*
5
Connecting cord supplied for your CD
changer
Other external component
Set the external input setting correctly—either “Changer,” “iPod,” or “D. player” (See page
42 of the INSTRUCTIONS.)
Select “External Input” for the external input setting (See page 42 of the INSTRUCTIONS.)
• iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
To antenna
See below
*
6
KS-PD100/KS-PD500 (separately
purchased)
Connecting the parking brake wire
You can connect amplifiers to upgrade surround system in the car compartment.
• Connect the amplifiers to 5.1-ch analog discrete output jacks to enjoy multi-channel source
(DVD Video/DVD Audio).
• To activate the center speaker, see page 40 of the INSTRUCTIONS.
•
Disconnect the speakers from the main unit, and connect them to the amplifier. Leave
the speaker leads of the unit unused.
A
Connecting the external amplifiers
B
Connecting the AV I/O cord
C
Connecting the TV tuner
JVC CD changer
*
3
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place
uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure
to do so may cause damage to the unit.
PARKING
BRAKE
To metallic body or
chassis of the car
Parking brake switch
(inside the car)
Parking brake wire (light green)
Parking brake
Crimp
Reverse gear signal extension
cord (Required only when connecting
a rear view camera to VIDEO IN plug.)
To reverse lamp
2nd monitor
(KV-MR9010, etc.)
Playback source
(Video camera, etc.)
Audio/video cords
(not supplied)
To car battery
Cordless headphones
(KS-HP2)
Crimp
Reverse lamp lead
Fan
Front
speakers
Center
speaker
Subwoofer
L
R
L
L
R
L
R
R
INPUT
INPUT
INPUT
R
L
INPUT
R
L
*
3
*
3
*
3
*
3
Amplifier
Amplifier
Amplifier
Amplifier
Rear
speakers
AUX Input Adapter KS-U58 (separately purchased)
3.5 mm stereo mini plug
Line Input Adapter KS-U57
(separately purchased)
External component
Audio cord
(not supplied)
External component
*
4
Do not use these terminals.
To disconnect the connector
Hold the connector top tightly (
1
),
then pull it out (
2
).
Reverse lamp
Ignition switch
