Masterpage:Right-No-Heading
Filename [DR-M1EK_10Editing.fm]
Page 91
August 29, 2003 6:40 pm
91
Connecting To A Dolby Digital Decoder
or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby Digital decoder or an amplifier with built-in DTS.
Make connections.
Connect the unit and a Dolby Digital decoder or an
amplifier with built-in DTS using either an optional
optical cable or an optional coaxial cable.
NOTES:
●
For Dolby Digital sound, set “DIGITAL AUDIO OUT” to
“DOLBY DIGITAL/PCM”. (
墌
pg. 93)
●
For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/
PCM”. (
墌
pg. 93)
CAUTIONS:
●
This unit has a dynamic range of more than 110 dB with
regards to its Hi-Fi audio capability. It is recommended that
you check the maximum level if you are going to listen to the
Hi-Fi audio signals through a stereo amplifier. A sudden surge
in the input level to the speakers may damage them.
●
Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the playback picture.
Back of unit
Note for connection:
Remove the protection cap
from the optical cable.
Optical cable
(not provided)
Dolby Digital
decoder or amplifier
with built-in DTS
To DIGITAL AUDIO
input
Coaxial cable
(not provided)
DIGITAL AUDIO OUT
(OPTICAL)
DIGITAL AUDIO OUT
(COAXIAL)
When you can’t switch the audio channel of a
bilingual programme
When the unit is connected with a digital audio device using
an optional optical cable and “DIGITAL AUDIO OUT” is set
to “DOLBY DIGITAL/PCM”, it is not possible to switch the
audio channel of a bilingual programme recorded on a
DVD-RAM or DVD-RW (VR mode) disc. In this case, perform
the following steps using the remote control to switch
“DIGITAL AUDIO OUT” from “DOLBY DIGITAL/PCM” to
“PCM ONLY”.
A
Press
SET UP
to access the Main Menu screen.
B
Press
w e
to select “DVD SET UP”, then press
ENTER
.
C
Press
w e
to select “AUDIO OUTPUT”, then press
ENTER
.
D
Press
rt
to select “DIGITAL AUDIO OUT”, then press
ENTER
.
E
Press
rt
to select “PCM ONLY”, then press
ENTER
.
(
墌
pg. 93)
F
Press
SET UP
to complete the setting.
G
Press
AUDIO
to select the desired audio channel.
(
墌
pg. 36, “Audio Channel Selection”)
DR-M1EK_10Editing.fm Page 91 Friday, August 29, 2003 6:42 PM