Filename [DR-M1EK_06Name.fm]
Masterpage:Left0
Page 28
August 15, 2003 7:53 pm
28
SAT CONTROL SET
Satellite Receiver
Control Setting
The following procedure is required if you receive
satellite channels through a satellite receiver.
Approximately 20 seconds before the VIDEO Plus+ timer
programming (
墌
pg. 56) or Manual Timer programming
(
墌
pg. 58) starts, the unit sets its input mode to “L-2” and
automatically switches the satellite receiver’s channels
using a provided Satellite Controller.
Installing Satellite Controller
A
Install a Satellite Controller.
Place a Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
B
Attach the Satellite Controller.
Fix securely using the adhesive strip attached on the back
of the Satellite Controller.
C
Make connections.
Be sure to connect the unit’s L-2 IN/DECODER connector
to the satellite receiver’s 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
D
Connect the Satellite Controller to unit.
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
Satellite receiver
Satellite Controller
(provided)
(suggested locations)
Transmitter
21-pin SCART cable
(provided)
SAT CONTROL
L-2 IN/DECODER
Your unit
Satellite Controller
(provided)
Satellite receiver
Back of unit
DR-M1EK_01.book Page 28 Friday, August 15, 2003 7:53 PM