JVC CA-D602T, Instructions Manual

Page: 21 / 48

19
On the Remote Control
To tune in FM stations, press FM.
To tune in AM stations, press AM.
COMPU PLAY
When FM or AM is pressed while the power is on standby, the power is automatically turned on.
Three Ways to Select a Station ——————————————
Press
1
TUNING DOWN or TUNING UP
¡
on the MULTI CONTROL repeatedly to move
from frequency to frequency until you find the one you want. (Manual Tuning).
OR
Press and hold
1
TUNING DOWN or TUNING UP
¡
on the MULTI CONTROL for a few
seconds, the frequency starts changing on the display. When a station is tuned in, the frequency stops
changing. (Auto Tuning).
OR
Possible only after presetting stations.
Press once and release
4
P. DOWN or
¢
P. UP on the MULTI CONTROL to go to the next
preset station.
You can also use the Remote Control to tune in preset channels:
1. Press FM or AM so that you can receive the last station tuned in.
2.
Select the station by entering the preset number in the number keys of the Remote Control.
•
Example: for channel 5, press 5. For channel 15, press +10 then 5.
For channel 20, press +10, then 10. For channel 30, press +10 twice then 10.
• After you have selected the preset number and the number appears, the broadcast frequency of the
selected channel appears on the display.
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM stations for the preset numbers.
Note:
In some cases, test frequencies have been already memorized for the tuner since the factory
examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations
you want into memory by following the presetting method.
1. Select a band by pressing FM/AM on the Unit.
When using the Remote Control, press FM or AM.
2. Press
1
TUNING DOWN or TUNING UP
¡
on the MULTI
CONTROL to tune into a station.
3. Press SET.
“SET” flashes for 5 seconds.
While it is still flashing, carry out the following procedure.
4. Press
4
P. DOWN or
¢
P. UP on the MULTI
CONTROL on the Unit to set the preset number.
5. Press SET again.
“STORED” appears for 2 seconds. The preset station is
stored in the memory.
6. Repeat steps 1 to 5 for each station you want to store in memory
using different preset numbers.
CAUTION: If the Unit is unplugged or if a power failure occurs, the preset
stations will be erased in a few days. If this happens, preset the station
again.
Changing the FM Reception Mode
When an FM stereo broadcast is hard to receive or noisy, press FM MODE on the Remote Control so that the
MONO indicator lights up on the display. Reception improves, but there is no stereo effect.
To restore the stereo effect, press FM MODE on the Remote Control so that the MONO indicator goes
out. In this stereo mode, the STEREO indicator lights up and you can hear stereo effects, when a program is
broadcast in stereo.
FM
or
AM
TEST TONE
CENTER MODE
DELAY TIME
L BALANCE R
CENTER
LEVEL
3CH LOGIC PRO LOGIC
– +
REAR
LEVEL
– +
1
3 , 5
2
4
or
or
or
FM MODE
EN/MX-D602T[J]/f 98.3.31, 2:25 PM 19