Analogue Solutions | FUSEBOX | Manual
Click right to turn XMOD on. This routes Square wave audio out from VCO2 to
VCO1 pitch. Used for amazing effects!
VCO2
DETUNE
Use this control to alter the pitch in small amounts to detune relative to the other
oscillators.
PITCH
This control is used to attenuate any modulation signal that you patch into the socket
below.
Examples of modulation signals are outputs from the LFO or EG, or from an external
modular system (eg Eurorack). An audio signal can also be used, such as the audio
outputs from the other oscillators.
PW - Pulse Width
This control allows you to manually change the pulse width of the Square waveform.
PWM - Pulse Width Modulation
Use this control to alter the amount external modulation that you patch into the
socket below.
Examples of modulation signals are outputs from the LFO or EG, or from an external
modular system (eg Eurorack).
Square / Sawtooth
There are separate jack socket audio outputs from the two VCO waveforms.
These can be patched to other circuits, for example, used to modulate the pitch of
another oscillator.
WIDE TUNE
Click right to dramatically increase the range of the DETUNE control. You can take
the frequency right down to LFO speeds, and right up to much higher pitches.
Fusebox - 30 Oct 2017
| Page
!
17