4.7 Installing the accessory drawer
6 720 608 487
2
2
1
Fixing screws
Flue gas elbow
Lamination diaphragm
1
Output connection
correspondingly on the inlet side of the flue gas fan.
8,5%
FIG. 13 Secure the flue gasket with a clamp
16
must be chosen according to
Rolling diaphragm mounting
Warning:
GPL
FIG. 14 Mounting the rolling diaphragm
The most suitable fit for the diaphragm
Tab. 6
B Place the mounting guides in the holes under the control panel
according to Fig. 16.
CO2 (%)
flue gas length (see instructions for flue gas
fittings).
Connecting flue gas accessories
1,1 - 1,4
B Install the diameter diaphragm (2) in diameter
Warning:
Rolling diaphragm to be
7,5%
NG
B Check all gaskets for proper positioning - finally tighten the Dutch pipe
connection nuts.
B To install the accessories, follow the attached installation instructions.
B Lower the mounting levers according to Fig. 15.
B Attach the flue gas elbow to the boiler outlet connection and push
it all the way in.
Installing
Binding accessories
The drawer must be installed after the boiler is fully
installed.
For more information on these installation
accessories, check their instructions.
ÿp (mbar)
FIG. 15 Mounting the levers
In order to facilitate the installation of the
drawer and to guarantee a correct service, the
entire alignment must be carried out.
Machine Translated by Google
