Juniper TX MATRIX, Hardware Manual

Page: 253 / 396

12.
Set the
M/S
switch on each T-CB faceplate to
S
.
13.
Set the
CHASSIS ID
switch on each T-CB faceplate to
0
.
14.
On an external management device connected to the console or auxiliary port of the
T640-CIP, load the original T640 router configuration. For example:
user@host# load override t640-config.conf
15.
If graceful switchover is enabled in the original T640 router configuration, disable it
as follows:
user@host# delete chassis redundancy graceful-switchover
16.
Issue the
commit synchronize
command and ensure that there are no synchronization
errors:
user@host# commit synchronize
17.
On an external management device connected to the console or auxiliary port of
T640-CIP-0 , reboot the corresponding Routing Engine in the T640 router:
user@host> request system reboot
18.
On an external management device connected to the console or auxiliary port of
T640-CIP-1
, reboot the corresponding Routing Engine in the T640 router:
user@host> request system reboot
19.
Display the status of the SIBs by issuing the
show chassis sibs
command on the master
Routing Engine:
user@host> show chassis sibs
Slot State Uptime
0 Spare 255 days, 31 minutes, 12 seconds
1 Online 255 days, 31 minutes, 12 seconds
2 Online 255 days, 31 minutes, 12 seconds
3 Online 255 days, 31 minutes, 12 seconds
4 Online 255 days, 31 minutes, 12 seconds
Verify that four SIBs are in the
Online
state and one SIB is in the
Spare
state.
20.
Delete all statements associated with
LCC0
from the TX Matrix router configuration.
To review the T640 router configuration changes that were merged into the TX Matrix
router configuration, see “Creating a Configuration File on the T640 Router for
Integration into the Routing Matrix” on page 167.
NOTE: You do not need to replace the rear fan tray with the original one.
221 Copyright © 2010, Juniper Networks, Inc.
Chapter 23: Troubleshooting TX Matrix Hardware Components