Copyright 2006 Tandberg Data and Exabyte, EZ17, M2, VXA, and VXAtape are registered trademarks; ExaBotics, MammothTape, and SmartClean are
trademarks; SupportSuite is a service mark. Linear Tape-Open, LTO, the LTO Logo, Ultrium and the Ultrium Logo are trademarks of HP, IBM, and Quantum in
the US and other countries. All other product names are trademarks or registered trademarks of their respective owners.
433680-01
October 2006
www.tandberg.com
I
NSTALLING
A
T
APE
D
RIVE
IN
This document explains how to install or replace a tape drive in the Tandberg
StorageLibrary T24 or Tandberg StorageLibrary T48. Please read the entire section that
you are using prior to beginning the procedure.
P
REPARING
FOR
I
NSTALLATION
OR
R
EPLACEMENT
Note:
If your library is installed in a rack, it is
not
necessary to remove the library from the
rack to complete this procedure. It is also not necessary to disconnect the Ethernet
cable from the back of the library.
Obtain these items
—a #2 Phillips screwdriver and a small flat-blade screwdriver.
Ensure that the environment is free of conditions that could cause electrostatic
discharge (ESD)
—If possible, use an antistatic mat and a grounded static protection
wristband during installation. If a mat and wristband are not available, touch a known
grounded surface, such as a computer’s metal chassis.
Warning
Before performing any installation or maintenance procedures, be
sure that the library’s power switch is off and that the power cord is
disconnected from the library and the outlet.
Warnung
Vor der Ausführung von Installations- oder Wartungsarbeiten ist
darauf zu achten, daß der Library-Netzschalter auf “Aus” gestellt ist
und daß das Anschlußkabel vom Library und der Steckdose entfernt
ist.
Advertencia
Antes de realizar cualquier procedimiento de instalación o de
mantenimiento, comprobar que el interruptor de alimentación de la
biblioteca está apagado y que el cable de alimentación no está
enchufado ni a la biblioteca ni a la toma de corriente.
