Juniper TX MATRIX, Hardware Manual, Page: 174 / 396

Related
Documentation
TX Matrix Software and CLI Overview on page 145
•
•
Performing the Initial Software Configuration for the TX Matrix Router on page 142
Performing the Initial Software Configuration for the TX Matrix Router
These procedures connect a router to the network but do not enable it to forward traffic.
For complete information about enabling the router to forward traffic, including examples,
see the Junos OS configuration guides.
You configure the router by issuing Junos OS command-line interface (CLI) commands,
either on a console device attached to the
CONSOLE
port on the TX-CIP, or over a telnet
connection to a network connected to the
ETHERNET
port on the TX-CIP.
NOTE: These procedures enable you to use the
ETHERNET
management
port. For the initial configuration, use a device attached to the
CONSOLE
port
on the TX-CIP.
1.
Entering Configuration Mode on page 142
2.
Configuring User Accounts and Passwords on page 142
3. Configuring System Attributes on page 143
4.
Committing the Configuration on page 144
Entering Configuration Mode
1.
Verify that the router is powered on.
2.
Log in as the root user. There is no password.
Amnesiac <ttyd0>
login: root
3.
Start the CLI.
root@% cli
root>
4.
Enter configuration mode.
root> configure
Entering configuration mode.
[edit]
root#
Configuring User Accounts and Passwords
For information about using an encrypted password or an SSH public key string (DSA or
RSA), see the
Junos OS System Basics Configuration Guide .
1.
Add a password to the root administration user account. Enter a clear-text password.
Copyright © 2010, Juniper Networks, Inc. 142
TX Matrix Hardware Guide