Table 9: SRX100 Services Gateway Built-In Hardware
Interfaces
(continued)
Description
Specifications
Interface Type
The USB port can be used:
•
To support a USB storage
device that functions as a
secondary boot device in
case of internal flash failure
on startup, if the USB
storage device is installed
and configured
NOTE:
You must install and
configure the USB storage
device on the USB port to
use it as secondary boot
device. Additionally, the
USB device must have
Junos installed.
•
To provide the USB
interfaces that are used to
communicate with many
types of Juniper-supported
USB storage devices
The USB port:
•
Consists of one port
•
Supports the following
modes:
•
Full speed
•
High speed
•
Complies with USB revision
2.0
Universal Serial Bus (USB)
The console port can be used:
•
To provide the console
interface.
•
To function as a
management port to log
into a device directly.
•
To configure the device
using the CLI.
The console port:
•
Consists of one port
•
Uses an RJ-45 serial cable
connector
•
Supports the RS-232
(EIA-232) standard
Console
NOTE:
The Reset Config button is used to remove the current configuration
and reset the device to the default configuration.
The button is recessed in the front panel to prevent it from being pressed
accidentally.
CAUTION:
Pressing and holding the Reset Config button for 15 seconds or
more deletes all configurations on the device and loads and commits the
factory configuration.
Related
Documentation
•
SRX100 Services Gateway Specifications on page 24
•
SRX100 Services Gateway Front Panel and Back Panel Views on page 13
Copyright © 2015, Juniper Networks, Inc.
16
SRX100 Services Gateway Hardware Guide for B and H Model Numbers
