JUNOSe 10.3.1 Release Notes
52
Resolved Known Problems
Resolved Known Problems
The following problems were reported open in Release 10.3.0 and have been
resolved in this release. For more information about particular resolved problems,
you can log in to the JUNOSe Knowledge Base at https://www2.juniper.net/kb/,
enter the defect ID number in the Search by Keyword field, and click Search.
AAA
The E Series router erroneously accepts two subscribers with the same IP
address instead of denying access to the second subscriber. [Defect ID 176260]
ARP
The
show arp
command does not populate the ARP entry after issuing the
clear arp
interfaceSpecifier
command. [Defect ID 177685]
ES2 4G LM reset type: panic message. Node already on free list free list ptr =
0x0238e8e4; file: statics.cc line: 413 [Defect ID 90120]
GE line card reset type: processor exception 0x300 ; pc: 0x2a2210 -
Arp::timerTick(unsigned long) [Defect ID 89849]
ATM
After you upgrade the router from 7-0-x to 9-1-x release the ATM subinterface
configuration change. [Defect ID 89456]
After upgrading port showing “cannot get operational” status on aal5 interface
(hardware not present) [Defect ID 90068]
SRP reset type: panic; file: apterLocation.cc; line: 179; task: snmp_Data_1.
[Defect ID 90202]
After you run the
redundancy revert
command, most of the PPPoE subscribers
do not come up on the line module. [Defect ID 183791]
BFD
bfdSessPerfSessUpCount MIB counts both Up and Down states [Defect ID
89783]
bfdSessUpTime MIB is displaying the value in Time Ticks of the ticks elapsed
since the last time the bfd session came up. bfdPerfLastSessDownTime MIB is
displaying the difference value in Time Ticks between the last bfdSession Up
time and the last bfdSession Down time. Both these values are inccorect as per
the RFC. [Defect ID 89795]
