■
On SRX650 devices, the T1/E1 GPIMs (2 or 4 port version) do not work in 9.6R1.
This issue is resolved in JUNOS Release 9.6R2 and JUNOS Release 10.1, but if
you roll back to the 9.6R1 image, this issue is still seen.
Interfaces and Routing
■
On SRX650 devices, MAC pause frame and FCS error frame counters are not
supported for the interfaces
ge-0/0/0
through
ge-0/0/3
.
■
On SRX240 and SRX650 devices, the VLAN range from 3967 to 4094 falls under
the reserved VLAN address range, and the user is not allowed any configured
VLANs from this range.
■
On SRX650 devices, the last 4 ports of a 24-Gigabit Ethernet switch GPIM can
be used either as RJ-45 or SFP ports. If both are present and providing power,
the SFP media is preferred. If the SFP media is removed or the link is brought
down, then the interface will switch to the RJ-45 medium. This can take up to
15 seconds, during which the LED for the RJ-45 port might go up and down
intermittently. Similarly when the RJ-45 medium is active and an SFP link is
brought up, the interface will transition to the SFP medium, and this transition
could also take a few seconds.
■
On SRX Series and J Series devices, the user can use IPsec only on an interface
that resides in the routing instance
inet 0
. The user will not be able to assign an
internal or external interface to the IKE policy if that interface is placed in a
routing instance other than
inet 0
.
■
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, the following multicast
IPv6 and MVPN CLI commands are not supported. However, if you enter these
commands in the CLI editor, they will appear to succeed and will not display an
error message.
■
show pim interfaces inet6
■
show pim neighbors inet6
■
show pim source inet6
■
show pim rps inet6
■
show pim join inet6
■
show pim mvpn
■
show multicast next-hops inet6
■
show multicast rpf inet6
■
show multicast route inet6
■
show multicast scope inet6
■
show multicast pim-to-mld-proxy
■
show multicast statistics inet6
■
show multicast usage inet6
136
■
Known Limitations in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers
JUNOS 10.1 Software Release Notes
