Jungheinrich ERE 224, Operating Instructions Manual

Page: 22 / 87

C 3
1003
.GB
In order to prepare the truck for work following delivery or transportation, the following
operations must be performed:
– Check the truck for completeness and satisfactory condition of the equipment.
– If necessary, install the battery. Do not damage the battery cable.
– Charge the battery (refer to chapter D).
– If necessary, check whether the setting of the combined instrument matches the
type of battery (refer to chapter D)
– Start the truck as described (refer to chapter E).
Z
When parked, the running surface of the tyres will flatten. The flattening will disappear
after a short operating time of the truck.
3 Moving the truck with the drive unit inoperative
F
This operating mode is not permitted when negotiating inclines and gradients.
If the truck has to be moved after a failu-
re affecting proper operation has rende-
red it immobile, proceed as follows:
– Set the master switch to position
“OFF”.
– Set the key switch to position “OFF”
and withdraw the key.
– Immobilise the truck, ensuring that it
cannot move.
– Open the front hood and remove it (re-
fer to chapter F).
– Loosen the lock nuts (5) and tighten
the screws (4).
This releases the brake so that the truck
can now be moved.
F
After arriving at the destination, ensure
that the brake system is restored to its
initial state. The truck must on no ac-
count be parked with the brake in the re-
leased condition.
– Turn out the screws (4) by approx. 5
mm again and secure them with the
lock nuts (5).
The brake is now applied again.
5
4
C 3
1003
.GB
In order to prepare the truck for work following delivery or transportation, the following
operations must be performed:
– Check the truck for completeness and satisfactory condition of the equipment.
– If necessary, install the battery. Do not damage the battery cable.
– Charge the battery (refer to chapter D).
– If necessary, check whether the setting of the combined instrument matches the
type of battery (refer to chapter D)
– Start the truck as described (refer to chapter E).
Z
When parked, the running surface of the tyres will flatten. The flattening will disappear
after a short operating time of the truck.
3 Moving the truck with the drive unit inoperative
F
This operating mode is not permitted when negotiating inclines and gradients.
If the truck has to be moved after a failu-
re affecting proper operation has rende-
red it immobile, proceed as follows:
– Set the master switch to position
“OFF”.
– Set the key switch to position “OFF”
and withdraw the key.
– Immobilise the truck, ensuring that it
cannot move.
– Open the front hood and remove it (re-
fer to chapter F).
– Loosen the lock nuts (5) and tighten
the screws (4).
This releases the brake so that the truck
can now be moved.
F
After arriving at the destination, ensure
that the brake system is restored to its
initial state. The truck must on no ac-
count be parked with the brake in the re-
leased condition.
– Turn out the screws (4) by approx. 5
mm again and secure them with the
lock nuts (5).
The brake is now applied again.
5
4