02
.0
8.
GB
F 20
10.6
DFG/TFG transmission:
M
It is important to check the oil level correctly. The oil is a lubricant which also acts as
a coolant and operates the clutches. A low oil level will result in loss of transmission
and pressure. It also causes overheating and resultant transmission failure.
Checking the transmission oil level
Z
Only use clean, fresh oil from clean
containers to fill or top up the
transmission. Damage will arise from
contamination or water entering the
transmission.
You access the transmission oil dipstick
on the right-hand side of the trans-
mission (looking in the direction of
travel).
– Start the motor and with the parking
brake applied, first engage forward gear followed by reverse and wait until the
transmission has reached operating temperature.
– When the motor is running in idle, remove the dipstick (25).
– Wipe the dipstick with a lint-free cloth and put in back fully into its port.
– Remove the dipstick again and check whether the oil level is between the MIN and
MAX markings.
– If the level is below the centre point, add the right grade of transmission oil through
the filler port (24) into the transmission unit, until it reaches the MAX marking on the
dipstick.
– Refit the dipstick in the port.
25
24
02
.0
8.
GB
F 20
10.6
DFG/TFG transmission:
M
It is important to check the oil level correctly. The oil is a lubricant which also acts as
a coolant and operates the clutches. A low oil level will result in loss of transmission
and pressure. It also causes overheating and resultant transmission failure.
Checking the transmission oil level
Z
Only use clean, fresh oil from clean
containers to fill or top up the
transmission. Damage will arise from
contamination or water entering the
transmission.
You access the transmission oil dipstick
on the right-hand side of the trans-
mission (looking in the direction of
travel).
– Start the motor and with the parking
brake applied, first engage forward gear followed by reverse and wait until the
transmission has reached operating temperature.
– When the motor is running in idle, remove the dipstick (25).
– Wipe the dipstick with a lint-free cloth and put in back fully into its port.
– Remove the dipstick again and check whether the oil level is between the MIN and
MAX markings.
– If the level is below the centre point, add the right grade of transmission oil through
the filler port (24) into the transmission unit, until it reaches the MAX marking on the
dipstick.
– Refit the dipstick in the port.
25
24
Summary of Contents for DFG 425
