Save switch-on brightness
Precondition: The buttons of a channel are set as channel buttons.
With dimmer actuators a brightness value can be saved to which the dimmer actuator switches
after a short button press.
o
Set required switch-on brightness.
o
Press both buttons of a channel simultaneously for longer than 4 seconds.
The light is briefly switched off and switched on again to the switch-on brightness. Switch-
on brightness is saved.
Polling sum status
Precondition: The buttons of a channel are set as channel buttons.
i
Polling is not possible with scene buttons.
o
Press both buttons of channel 1 for up to 4 seconds simultaneously.
Signalling of radio transmission and group status (see function of the LED in operation)
5 Information for electrically skilled persons
5.1 Mounting and electrical connection
Fitting the device
Precondition: To ensure good transmission quality, keep a sufficient distance from any possible
sources of interference, e.g. metallic surfaces, microwave ovens, hi-fi and TV systems, ballasts
or transformers.
o
Change the battery (see chapter Changing the battery).
o
Screw or glue the base plate (1) to an even surface. The
TOP/OBEN
label has to be at the
top.
o
Position the design frame (3) on the base plate.
o
Screw wall transmitter module (4) to base plate.
i
Screwing the screws too tightly could impair functions of the wall transmitter.
o
Snap on the buttons (7) (see chapter 2. Device components).
Information on gluing mounting
Precondition: To be able to fasten the wall transmitter safely, the surface must be flat and free
of dust and grease.
o
Remove the rear, unpunched film of the enclosed adhesive pad.
o
Align the adhesive pad, stick it to the surface and smooth it out. Remove air bubbles.
o
Remove the two inner segments of the front film.
o
Align the base plate to the external punching and stick it on.
i
In the case of multiple combinations, the abutting sides of the adhesive pads must be cut
along the external punching using a ruler and a cutter (figure 3).
4/10
32595513
J0082595513
22.03.2017
eNet radio transmitter module
