i
The connections in the actuators are preserved and must be deleted separately.
o
Press the top left (10) and bottom right (11) buttons simultaneously for longer than
20 seconds (figure 4).
After 4 seconds, the transmission LED (9) flashes. After 20 seconds, the transmission LED
flashes faster.
o
Press the desired button briefly.
The transmission LED flashes more slowly.
The channel button or scene button has been reset. The setting as channel button or
scene button is retained.
Resetting wall transmitter to the default setting
The connections to the actuators are disconnected and parameters are reset to default setting.
i
The connections in the actuators are preserved and must be deleted separately.
o
Press the top left (10) and bottom right (11) buttons simultaneously for longer than
20 seconds (figure 4).
After 4 seconds, the transmission LED (9) flashes. After 20 seconds, the transmission LED
flashes faster.
o
Release buttons and press the top left (10) and bottom right (11) buttons simultaneously
once again.
The transmission LED flashes more slowly for approx. 5 seconds.
The wall transmitter is reset to default setting. All the buttons are set as channel buttons.
6 Appendix
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
6.1 Technical data
Rated voltage
DC 3 V
Battery type
1×Lithium CR 2450N
Ambient temperature
-5 ... +45 °C
Degree of protection
IP 20
Protection class
III
Transmitting range in free field
typ. 100 m
Radio frequency
868.0 ... 868.6 MHz
Transmission capacity
max. 20 mW
Receiver category
2
6.2 Parameter list
The device parameters can be changed with the eNet server:
Device configuration
Parameter name
Setting options, Basic
setting
Explanations
8/10
32595513
J0082595513
22.03.2017
eNet radio transmitter module
