JUMO TYA S201, Operating Manual, Page: 79 / 92

V1.00/EN/00709718 [Thyristor power switch TYA S201] 79
8 Error messages and alarms
8.1 Binary signal for collective fault
This signal is used for controlling the digital output and LED K1, and can also
be read out from the power controller via the interfaces.
You can use the setup program to configure which events (alarm and error
messages) are to be grouped together as a binary signal for a collective fault.
TYA 200 Series This selection contains all of the events that are used in the TYA 200 Series.
Some events, such as "Slave 2 load fault" are not relevant for the TYA S201
devices because they are not used.
All fault messages are OR-linked and output as a binary signal for a collective
fault on the relay output or optocoupler.
In addition, LED K1 lights up yellow.
This alarm can switch a relay at the digital output.
v
Chapter 5.1.7 "Binärausgang"