JUMO TYA S201, Operating Manual, Page: 54 / 92

5 Configuration
54 V1.00/EN/00709718 [Thyristor power switch TYA S201]
5.1.4 Setpoint value configuration
This setting determines which input specifies the setpoint value, how high the base
load is, and which alternative value should be applied in the event of malfunction.
Value / settings Description
Setpoint specifica-
tion Current input This setting specifies which analog input supplies the setpoint
value for the power output.
Note:
These inputs can also be used for logic operation.
v
For switching level, see Chapter 10.7 "Allgemeine
Kenndaten"
Voltage input
Via interface Means that the setpoint value for the power output is provided
via an interface.
Input in the event of
an error Current, voltage, and interface input are monitored for errors
(wire breaks or bus errors). This setting specifies which re-
placement value the power controller should use if the set-
point specification is incorrect.
The last valid value is used per default.
Last value
Voltage input or cur-
rent input
If, for example, an error (e.g. wire break) now occurs at the
current input that is selected for the default setpoint value, the
power controller uses the value at the voltage input.
Value, adjustable This means that the "Value in the event of an error" is used.
Value in the event
of an error 000.0 This value is used in the event of a malfunction.
Base load 0 to 100 % Note:
This setting is only available if Power controller
r
Thyristor
control
r
Continuous (power controller) is selected.
k
/ bold = default setting
Control signal
P
Base load: 680 W
Maximum
Output level: 3680 W
0 mA
20 mA
3000W 0...20mA
Ⳏ
Base load