JUMO PINOS L02, Operating Manual

Page: 65 / 92

19
5 Electrical connection
5 Electrical connection
5.1 General information
CAUTION!
The electrical connection must only be carried out by qualified personnel.
The temperature of 60 C can be exceeded at the connection terminals.
5.2 Electrical data
The choice of cable material, the installation, and the electrical connection of the device must conform
to the requirements of VDE 0100 "Regulations on the Installation of Power Circuits with Nominal Voltag-
es below 1 000 V" or the appropriate local regulations.
The device must be completely disconnected from the mains voltage if there is a risk of contact with live
parts during work on the equipment.
In addition to a faulty installation, incorrectly set values could also impair the orderly function of the down-
stream process or lead to other damage. Access to settings should only be given to qualified personnel.
Please observe the corresponding safety regulations in this context.
Voltage supply DC 24 V ±10 %, SELV
Requirement The device must be equipped with an electrical circuit that
meets the requirements of EN 61010-1 with regard to "Limited-
energy circuits".
EMC Acc. to DIN EN 61326-1
Interference emission Class A – only for industrial use
Interference immunity Industrial requirement
Current consumption Analog output – flow sensor: ≤ 150 mA
Switching output – flow switch: ≤ 350 mA