JUMO LOGOSCREEN cf, Interface Description

Page: 5 / 32

5
1 Introduction
1.1 Preface
Warranty
Data backup
Update CD
for paperless
recorder For interlinking the modules, you will need the JUMO mTRON-iTOOL project
design software, which has been created especially for devices from the
mTRON series.
For this reason, the driver data for the paperless recorder must be re-installed
in the module library.
Operating
Instructions
B 70.6570.2.1
H
If any problems should arise during start-up, you are asked not to
carry out any manipulations on the unit. You could endanger your
rights under the warranty. Please contact the nearest subsidiary or
the head office in such a case.
A
Back up your configuration files at regular intervals.
If you reformat the hard disk, the projects that you have created with
the JUMO mTRON-iTOOL will also be deleted!
H
All necessary information for operating the interface is contained in
these operating instructions.
Please read this manual before starting up the interface. Keep the
manual in a place which is accessible to all users at all times.
Please assist us to improve this manual, where necessary.
Phone +49 661 6003-0
Fax +49 661 6003-607
email mail@jumo.net