JUMO flowTRANS US W02, Brief Instructions

Page: 26 / 48

7 Electrical connection
26
Digital output – PNP
7.2 Connecting the device
Device Connecting cable
+24 V
GND
≤ 200 mA, ≤ 10 kHz
(1)
(2)
(4)
(3)
I/O Pin 2
I/O Pin 1
1. Insert the connecting cable into
the M12 plug connection.
2. Manually screw the union nut of
the connecting cable onto the
M12 plug connection on the de-
vice
If using the connecting cable
provided by the manufacturer,
tighten the union nut using an
SW13 open-end wrench.
Maximum tightening torque:
0.4 Nm.
3. Connect the connecting cable to the device that is processing the signals and to the voltage supply.
Route the cable so that it is protected against mechanical strain.
The device is ready for operation as soon as the voltage supply is established.  "Startup
display", Page 27.