ENGLISH
Use
1.
First check that the power switch is switched off – risk of personal injury or material damage if the
appliance is incorrectly assembled.
2.
Check that the juicer filter and rotor are correctly positioned and that the filter and transparent lid
have not come skew. Put on the transparent lid, fasten the locking lever in the slot on the lid, and
start the appliance.
3.
All the parts must be fitted as shown in the diagram under Description. Start the appliance and
allow it to run empty for about five seconds. Insert the prepared fruits and/or vegetables into the
feed tube and slowly press down with the feeder.
NOTE:
Press down the feeder with a slow and constant pressure. Do not press too hard, this will reduce
the functionality of the motor and juicer.
Time limit
The appliance has a knob with three settings:
O
(stop),
I
(low speed) and
II
(high speed). When selecting
high speed: allow the appliance to work for 1 minute, stop and rest for 1 minute. Start again. When you
have started and stopped three times the appliance must be allowed to stand at rest for 15 minutes. Do
not start the appliance again until the motor has cooled. This prolongs the service-life of the motor and
improves the functionalitiy of the appliance.
MAINTENANCE
•
Make sure the motor is always dry and clean.
•
Store the appliance in a dry place with good ventilation if it is not going to be used for some time to
prevent moisture getting into the motor.
•
Never clean the motor unit in water. Only clean with a lightly moistened cloth. The other parts, such
as feeder, lid, juice jug and pulp container, can be cleaned in water.
Subject to printing errors and design changes over which we have no control. In the event of problems,
please contact our service department.
www.jula.com
13