– 81 –
Adjustment Procedure
Results of Improper Adjustment
Configuration of lubrication mechanism parts is as shown in the drawing.
1. Float case
Pull up the float case
straight from the float case guide
to take
it out.
Remove and adjust the lubrication pipe
and others within the
permissible range where they can be stretched.
The float case guide
has a notch groove with orientation.
Push it straight along the groove to make a joint.
(Push it until there is a feeling of coupling with a click sound.)
2. Float
The float
has an orientation.
Insert it in the float case
with its flat plane positioned on the right
as seen from worker side.
Be careful not to bend the bar of the float
.
3. Float case guide
Put the float case guide
in the guide groove section of the peep
window
and fix it to the bed.
4. Peep window
Remove the window plate located behind the arm. It is fixed to the
arm.
5. Oil filter
The oil filter
can be cleaned after removing the lubrication pipe
fixing ring
and pulling out the lubrication pipe
.
Part name
Part No.
Float
40086648
Summary of Contents for DDL-9000B-DS
