– 79 –
Adjustment Procedure
Results of Improper Adjustment
1. Apply appropriate grease to the roller (arm’s vertical sliding section)
of the needle bar connecting section.
2. Apply appropriate grease to the intermediate presser bar connection
and arm’s sliding groove section.
[DDL-9000B-SS, SH only]
3. Confirm that the needle bar
keeps an exact contact with the oil
wick
in the position 5mm below the needle bar upper bushing
.
If there is no contact, correct it by means of the oil wick support
plate
.
(Cautions) Apply a piece of paper to the oil wick
and confirm
whether it is wet with oil.
o Grease is not required for the
presser bar
.
If grease is applied, contamination
like black ink is caused by the
presser bar bushing
and the
material cloth may be stained.
o This can be a cause of seizure
between the needle bar
and the
needle bar upper bushing
.
Summary of Contents for DDL-9000B-DS
