JUDO PROMI
9
Installation
–
The water temperature must not exceed
30 °C (86 °F)! At higher temperatures or
direct sun radiation the material can be
damaged and the filter housing may
even break.
–
In order to be able to safely discharge
the wastewater in operation and in case
of any defects that occur in the system,
precise compliance with the details giv-
en in the “Installation” chapter is neces-
sary! If the wastewater (backwashing)
cannot be safely and completely dis-
charged, water damage can occur.
–
A shut-off valve must be installed up-
stream of the filter! This enables the wa-
ter supply to the filter to be interrupted
during installation, servicing/mainte-
nance, repairs and in case of malfunc-
tions. Floods and serious water damage
can therefore be avoided.
–
The unit can be installed in all standard
drinking water pipes.
–
It is not permitted to install the filter
upstream of the water meter!
4.1.2 Installation position
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Always install the filter in a vertical position
(± 5°)!
Non-observance of this can cause uncon-
trolled leakage of backwashing water and
can result in water damage.
4.1.3 Mounting the built-in rotary
flanges
Install using the supplied built-in rotary
flange. The built-in rotary flange is used as a
connecting element between the pipe and
the filter.
It is suitable for both horizontal and vertical
pipes.
The built-in rotary flange must be in-
stalled in the direction of flow. This is
marked by a cast in arrow (see fig. 3).
Failure to comply with this will result in the
filter not working.
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
The flange surface of the built-in rotary
flange must be in a horizontal position! The
built-in rotary flange must be fitted so that
mechanical stresses cannot occur! Other-
wise mechanical damage can result in the
built-in rotary flange and damage can result,
the pipe may burst or the built-in rotary
flange can break. This can result in major
water damage and personal injury.
Therefore, during installation, ensure that no
stress forces act on the pipe, built-in rotary
flange and filter.
The shipping carton can be slipped
over the built-in filter to prevent
damage, for instance at construc-
tion sites.