8
JUDO PROMI
Product Information
3.
Product Information
3.1
Intended purpose
This filter is suitable for use in cold drinking
water up to a maximum water temperature
of 30 °C (86 °F).
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Please refer to the chapter on “Intended
Use” for use restrictions.
This filter removes coarse and fine-grained
particles from the water which are larger
than or equal in size to the mesh size of the
filter.
3.2
Materials used
The materials used are resistant to the phys-
ical, chemical, and corrosive loads to be
expected in the drinking water and fulfill the
requirements specified in DIN EN 13443-1
and DIN 19628 (“Mechanical filters in
drinking water installations”) and DIN EN
1567 ("water-related containment fittings -
pressure reducers and pressure-reducer
combinations") / required standards.
All materials are hygienically and physiologi-
cally uncritical. Plastics fulfill the require-
ments of the DVGW work sheet W270.
Metallic materials fulfill the requirements of
DIN 50930-6 (Impact on the Drinking Water
Quality).
4.
Installation
4.1
General
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
The unit may only be installed by skilled per-
sonnel.
The chapter on “Intended Use” must always
be observed!
The piping must be able to safely support
this product.
Otherwise mechanical damage or fractures/
bursts can occur in the pipes. This can result
in major water damage and personal injury.
Therefore, if necessary, the pipes must be
additionally fixed or supported.
For convenient operation and maintenance
it is absolutely necessary to ensure the giv-
en spacings (see chapter “Discharging the
backwashing water”).
A space of at least 200 mm (8 inch) should
be maintained above and below the filter.
These distances are necessary to be able to
properly carry out the backwashing (see
chapter “Backwashing”).
4.1.1 Requirements for the place of
installation
The room where the unit is installed must
be dry and frost free!
Unauthorized persons must not have ac-
cess to the filter!
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Particles smaller than the supplied
mesh size and impurities causing
turbidity cannot be filtered out of the
water.