JUDO PROMI
7
Intended Use
2.
Intended Use
The installation and operation of the filter is
subject to the following existing national
regulations.
In addition to the operating instructions and
the obliging regulations concerning accident
prevention that exist in the country of opera-
tion and the location of use, the established
technical regulations concerning safe and
professional work, should also be observed.
The water to be filtered must be drinking
water quality !
It is absolutely essential that the manufac-
turer / supplier will be consulted prior to any
operation of the device using water of a
different quality, respectively with water that
contains additives.
This filter is suitable for use in cold drinking
water up to a maximum water temperature
of 30 °C (86 °F).
The filter has been developed and manufac-
tured using state of the art technology and
the established safety regulations in
Germany.
The filter may only be operated in accor-
dance with the manufacturer’s specifica-
tions. Any other operation or operation
beyond the specified use, is not in accor-
dance with the manufacturer’s specifica-
tions.
Additional dangers may result in the event of
the device not being operated in accordance
with the manufacturer’s specifications and
non-observance of the danger symbols or
safety instructions. The manufacturer /
supplier cannot be made liable for any
damages caused by these additional
dangers. The operator is responsible for
these risks.
The use of the device in accordance with the
customer’s specifications includes the
observance of the operating instructions.
The manufacturer / supplier should be
consulted prior to any operation of the filter
other than in the operational areas stated in
these operating instructions.
The filter may only be operated in a techni-
cally faultless condition, in accordance with
the manufacturer’s specifications and the
stated safety and danger relevant instruc-
tions and under observance of the operating
instructions!
Any functional defects are to be removed
immediately!
2.1
Water Pressure
The water pressure should be between
2 psi and 16 psi.
The water pressure must not be below
2 psi as otherwise the backwashing can be
impaired! If the filter is not backwashed
regularly a pressure loss can result and this
can impair the filter function.
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
In the event of water pressure above
16 psi, a pressure reducing valve should be
fitted in front of the filter (see fig.4). If the
operating pressure is above 16 psi, this may
result in defects during operation.
2.2
Notes on special dangers
2.2.1 Electrical equipment /
installations
Electrical devices / equipment that are not
splash-water proof and are situated in the
direct vicinity of the filter may be damaged
by water leaking from the filter caused as a
result of the device not being operated in
accordance with the manufacturer’s specifi-
cations. In the event of such cases persons
are at risk and may sustain electrical
shocks. Therefore any electrical devices /
equipment situated in the direct vicinity
should be splash-water proof, respectively
comply with the statutory requirements for
wet areas. Always check with local authori-
ties prior to installations.
There must not be any electrical
cables and devices underneath or
in the immediate vicinity of the filter!