14
JUDO i-soft
Installation
4.6
Wastewater connection and
back-up overflow hose
The hoses for the regeneration wastewater
and the back-up overflow must both be laid
up to the wastewater sewer without any
kinks. Ensure free discharge above the
wastewater channel or floor drain.
The waste water hose with 11 mm (0.4 inch)
of outside diameters may not be shifted to a
position higher than the control actuator.
The tube length may amount to maximum
3 m (118 inch). Securely fix the loose end of
the hose to the pipe or similar with the adhe-
sive tape supplied.
The back-up overflow hose with a 19 mm
(0.7 inch) outer diameter must be laid with a
constant fall to the wastewater sewer and
free of kinks.
If the connection for the wastewater sewer is
higher than this, the salt container can be
installed correspondingly higher with the aid
of a wall bracket (see chapter “Accesso-
ries”).
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
An adequately dimensioned wastewater
connection (e. g. floor drain) to DIN 1986, or
local equivalent, must be available for the
wastewater and the back-up overflow hose.
